| 1. Print this activity.
Print this page and your Life in a Bottle Journal.
2. Clean the bottle.
Rinse your empty 2-liter bottle and peel off the label.
3. Measure and cut the bottle.
Measure 5 inches from the bottom of the bottle and make a mark. Repeat four times to make five marks around the bottle. Then connect all the marks to create a cutting line around the entire bottle and cut the bottle along the line carefully with scissors. |
 |
4. Add rocks and soil.
Fill the bottom section of the bottle with a one-and-a-half inch layer of rocks or gravel. Place soil on top of the rocks until the bottom section is halfway filled.
5. Plant seeds.
Plant seeds according to the instructions on the package.
6. Water.
Water your seeds with approximately one-half cup of water.
7. Close it up.
Place the top of the bottle back on (with the cap in place) and tape it shut.
8. Place in sunlight.
Put your bottle in direct sunlight.
9. Check daily.
Check your greenhouse every day. If there are always many water droplets on the inside of the bottle, if mold or mildew forms, or if water runs down the sides of the bottle, you need to take the top off of your greenhouse for the night. If no water droplets are forming, your greenhouse needs just a little more water.
10. Observe and record what you see.
[ Write your observations in the Life in a Bottle Journalthe amount of water droplets that form in the bottle, how much water collects at the bottom of the bottle, when your seeds start to sprout, and how much the seeds grow each day. Observe for at least two weeks after the seeds have sprouted, and then keep observing your greenhouse for as long as you like.
|